|
Post by MartyB on Mar 20, 2008 5:34:12 GMT
Topic pretty much says it all.
What I am looking for is the keel depth, length at hull, and bottom of keel. I am thinking of getting a keep faring kit from East coast US folks, and need these measurements. Of course when Amoretto was out of the water last june, I did not think nor know what I would need at the time......GRRRRRRRRRR>..
So any way, if one of you maybe on the east coast that is still out of the water can measure, or Europe, I would appreciate it.
Also if an Attalia owner is out of the water and can measure, this place has a pre made up set for that boat, not sure of the Arcadia keep is the same.............
marty
|
|
|
Post by MartyB on Jan 21, 2010 5:04:49 GMT
Lets pull this oldy but goody out, and see if any Arcadia owners are looking in here. still need an answer!
|
|
|
Post by renegade27 on Jan 21, 2010 22:44:03 GMT
Marty, is the Arcadia's keel cast steel? I'm curious about doing the same with my SO35 but it really seems like a big job...
Good luck finding the dimensions!
|
|
|
Post by MartyB on Jan 21, 2010 23:55:48 GMT
My Keel is steel like "most" Jeanneau keels. The SF37's had a lead keel, the SO's were steel.
I can get templates, but need the keel demensions. Being as only have to pull here in puget sound when it is time to paint, do maintenance, it is not worth pulling for an hour at this time just to measure. Hoping to paint, fair the keel this summer. If I had the $$$, the marina I am at has a half off dry moorage and hauling right now.......
|
|