dirkb
Junior Member
Posts: 17
|
Post by dirkb on Dec 3, 2023 19:02:24 GMT
After buying a NC11 recently, I found out that the trim cilinders for my heck drive push the upper site of the drive against the lower site of the swimming platform.
I think the cilinders are not set for the right angle. What should be the angle? If I look at the different types of cilinder, I find Full, 42° or 32°. Does anybody know the right angle?
|
|
|
Post by Hanzel on Dec 3, 2023 20:11:29 GMT
Hi Dirkb, congrats with your new boat, NC11 is great! Known issue that the drive can touch the swim platform, perhaps due to new mounted trim sender however very easy to solve by calibrate it. See attached the procedure at page 2. Advise to calibrate both drives, succes and enjoy. Hans calibration evc-d.pdf (591.33 KB)
|
|
dirkb
Junior Member
Posts: 17
|
Post by dirkb on Dec 3, 2023 21:30:58 GMT
Super, thanks Hanzel,
I’m gonna give it a try as soon as the winter is over.
Regards,
Dirk
|
|