|
Post by petersailor on Jul 2, 2017 16:06:28 GMT
I have a problem with the LCD screen on the combined battery/water/fuel gauge on the switch panel of my 2007 SO 42 DS, in that it lights up but does not display any digits or letters or pictograms; in fact, nothing.
Does anyone know how to cure the problem or where to get a replacement?
Many thanks,
|
|
|
Post by Tafika II on Jul 2, 2017 16:13:17 GMT
Not had this problem, but suggest you look at the backside to see if any wires entering the PCB are frayed or loose, check the connection and do a hard restart by pushing the center button and holding it. Other than that...I don't know what to suggest.
|
|
|
Post by petersailor on Jul 6, 2017 14:33:57 GMT
Thanks Brent, have tried both those. At my wits end with it...
|
|
|
Post by Tafika II on Jul 6, 2017 16:26:58 GMT
You probably should contact Jeanneau or the gauge manufacturer as it's probably bad. I use this gauge only as a reference for fuel and water. I have a seperate accurate voltage/amp Blue Sea M2 OLED Monitor which I installed (easy job) as I was getting battery alarms (always in the middle of there night) with the Jeanneau factory system. Now their system has the alarm turned off.
|
|
jmandeno
New Member
Posts: 3
Jeanneau Model: SO 519
Yacht Name: Five O’Clock
Home Port: Auckland
Country: New Zealand
|
Post by jmandeno on Mar 22, 2018 1:54:11 GMT
Had the same problem myself. Solved by turning the house batteries off for 15 seconds and then back on. The LCD screen rebooted itself.
|
|